MINIM BIN & POWER SUPPLY UNIT Type : MB404 manufactured by NUCLEONIX is primarily designed with the objective of conserving bench space and to achieve significant saving in cost of the Minimbin based Nuclear Counting Systems. Minimbin systems have the advantage of modularity in the system integration. This results into flexibility in interchangeability of functional modules. A small control panel not occupying any of the available module space is located at the right side of the bin, providing control switches, test points and indicator lamps.
||Mechanical Tolerance are in accordance with TID 20893 (Rev) enable interchangeability of all NIM standard modules .
||Standard rack 8 ¾ inches high and 8 single bits wide excluding, control panel.
|DEPTH BEHIND PANEL
||Approximately 10.9 inches.
||8 NIM standard connectors (42 pin as per AEC specifications) at the panel as specified by Nucleonix, wired in parallel for standard voltages.
||All the EIGHT connectors are wired for +12V,-12V,+24V and -24V and high quality GND in accordance with TID 20893.
||Bin is constructed with two side aluminium with casted handles, top and bottom grilled steel rod mesh with two side channel supports, module guides and a connector plate at the back and a two bit space reserved for power supply module.
||11.75″ width x 11.00″ depth upto connector plate x 8.75″ height.
Power Supply unit
|POWER SUPPLY UNIT
||This is a compact enclosure seated at the rear side of the bin which generates and provides DC supplies to all the bussed power connectors of the bin.
||230V AC, 50Hz, +/-10% variation allowed.
||+12V DC @1.5A, -12V @1.5A, +24V DC @0.75A, -24V @0.75A. 70watts maximum output.
||Better than +/-0.1%/td>
|NOISE AND RIPPLE
||Less than 10mV (rms) as observed at the power supply output connector level.
||+/- 5% minimum range.
||Input AC lines fused. Output is protected against short circuit and power supply recovers fully on removing the short circuit.